V1.1
PROCUT45 PLASMA CUTTER
8611303
Visit www.princessauto.com for more information
23
2. Connect the earth lead to the output terminal (E) of the
machine and tighten.
3. Connect the compressed air/gas supply to the air
connection (L) located at the rear of the machine. Turn on
the air/gas supply (Fig 3-1).
4. Connect the machine to the correct power supply and
switch on the machine using the ON/OFF switch (K)
located at the rear of the machine.
5. Select 2T / 4T operation (Fig. 4-1)
5.1 2T – The arc starts when the trigger is squeezed. The
arc stops when the trigger is released. The trigger must
remain depressed to maintain the electric arc.
5.2 4T – The arc starts when the trigger is squeezed and
released. Squeeze and release the trigger a second
time to stop the
electric arc. The
electric arc is
maintained without
having to hold the
trigger.
6. Select Gas Check/Cutting Mode (Fig. 4-2).
6.1 Gas Check – Determine if the gas or air is flowing. Press
the button to switch to Gas Check and the indicator will
light up. Pull the trigger and gas should flow out of the
nozzle. The machine does not supply an electric arc when
in this mode.
6.2 Cutting Mode - Press the button again and the cutting
mode LED will light up. The machine is now able to cut.
7. Set amperage control dial (I) to desired amperage.
Fig. 3
Fig. 4
