8611303
PROCUT45 PLASMA CUTTER
V1.1
22
For technical questions call 1-800-665-8685
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included
Identification Key. Dashed numbers in parenthesis (Fig. 1-1)
refer to specific point of an illustration or image.
INSTALL THE AIR SOURCE
The plasma cutter uses compressed air with the plasma arc to
create an ionized cutting arc. A compressor is the best choice
to provide air, but a cylinder of compressed air may be an
option when a compressor is not available.
1. Follow operating and set up instructions in the compressor’s
manual before connecting to the plasma cutter.
2. Connect the air hose to the air inlet (L) on the back of the
plasma cutter. Use thread sealant to prevent air leaks.
3. Install an air dryer on the compressor air hose to prevent
moisture from reaching the plasma cutter. Remember to
compensate for the slight loss of air pressure the air dryer
will cause.
SET UP PROCEDURE FOR
PLASMA CUTTING
Please install the machine strictly according to the
following steps.
1.
Connect the plasma torch to the plasma cutting machine.
Insert the plasma torch cable connector into the torch
connection (F)
and screw hand tight. Do not bend the pins
inside the torch connector (Fig. 2).
Fig. 2
