Sentry by Orion
Orion
Semi-Automatic Stretch Wrapping Machine
Revision 2.8
System Operation
27 August 2014
Page 3-10
The Up/ Down Program
Up/ Down mode will wrap the number of top wraps chosen in the parameters previously
described, then wrap the bottom wraps chosen in the parameters previously described and
repeat this process for the number entered in the Up and Down Num parameter. The cycle
will then end. The operator must then sever the wrap between the carriage and the load
and remove the load with a forklift or pallet jack (with optional ramp.)
1.
On the Program Screen, press
1
to choose the Up/ Down program to run.
2.
Press
0
or the green
Program Execute
button to start the Up/ Down cycle. The table,
up, and down indicators will show when the table is running and when the carriage is
moving up or down. While running this program, you may also choose the following:
A.
Press +/- to pause the wrap cycle. The carriage will remain at the location it was at
when the machine was paused. Press
0
or the green
Program Execute
button to
resume the current cycle.
B.
Press
CLR
to stop the wrap cycle. The carriage will move down to the start point.
C.
You may leave the Up/Down screen displayed if you are going to wrap multiple
loads. If not, press
ESC
when the cycle is complete to choose a new program.
Figure 3 - 14
The Up/ Down Mode
Screen
