For specific information related to your gauges, refer to the materials in your owner’s package that was provided
by the gauge manufacturer.
Sea Water System
Note:
Raw water for the baitwell tubs and raw water washdown
system comes through the seacocks, to the pumps and then to the
applicable baitwell tub and/or raw water washdown outlet. Before
turning on and of the sea water pumps from the helm, check to be
sure that the seacock is open.
For access to the seacock, remove the seat cushion over the transom
seat then open the hatch below the seat.
The seacock is wide open when the yellow seacock lever is vertical.
When the yellow seacock lever is horizontal, the seacock is closed.
The seacock should remain closed when the pump is not in use.
Baitwell Systems (Standard and/or Optional)
Your boat can be equipped with one (1), two (2) or three (3) baitwell tubs providing you with a baitwell capacity of
more 85 gallons. The port aft (standard) and starboard aft (optional) baitwells are located at the transom and
each have a 38-gallon capacity. Both of these baitwell tubs come equipped with a baitwell pump, seacock,
aerator head, baitwell light and standpipe. The third baitwell is located forward of the console (optional), has a
10-gallon capacity and includes an aerator head and standpipe.
The baitwell switches (Baitwell 1 and Baitwell 2) at the helm control the baitwell pumps. The pumps are mounted
on top of the seacocks in the bilge and are accessible via the bilge hatch below the transom seat.
To operate the baitwell system: Locate the
applicable baitwell switch on the console and press
the switch to the forward position to turn on the pump.
When the baitwell pump is operating, go to the
baitwell tub, open the baitwell lid and visually check
to see if water is pumping into the tub through the
aerator fitting. If water is not entering the baitwell tub,
the aerator fitting may not be open. See the photos
below to make sure that the lever on the aerator
fitting is in the open position. To turn the baitwell
pump off, press the baitwell switch to the aft position.
You should always turn the baitwell switch off at the
helm if the pump is not going to be used soon.
Seacock lever is shown in
the closed position.
Baitwell pump installation for the port aft
(standard) and starboard aft (opt)
Lever on the aerator fitting is closed
Lever on the aerator fitting is open
22
