If you have selected the optional starboard aft baitwell system, it will come equipped with a baitwell light. Use the
switch labeled baitwell 2 to operate this baitwell light.
Navigation / Anchor Lights
The navigation and anchor lights are required to be used for operation at night or under low visibility conditions to
indicate your position to other boaters. Visually verify the operation of your navigation and anchor lights and
verify that the lights are free from obstructions. You should check your lights monthly during optimum visibility
conditions.
•
When you are underway in low visibility conditions, you should have the Nav/Anc switch in the up
or forward position. This will activate the navigation lights, as well as your anchor light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor light. Press
the Nav/Anc switch to the down or aft position to turn on the anchor light.
Navigation/Bow Light - The navigation light is a 12” high post light that gets installed in the outlet that is mounted
at the bow of the boat.
Anchor Light - The U.S. Coast Guard requires that the anchor light be installed at the highest point on the boat
and must be secured in the up position when you are underway. Therefore, this light will be installed as follows
based upon the optional top that you may have selected:
•
T-Top (Canvas) – The 12” high mast light will be mounted on top
•
Bimini top or no top – Outlet for the removable 60” high mast light will be installed on the forward
edge of the motor well.
Spreader Lights (Optional)
The installation of the spreader lights requires the optional canvas T-
top. The spreader lights are mounted to the aft side of the T-top frame.
The switch for the spreader lights is installed on the console, separate
from the switch and breaker panel.
Depress the switch to the forward position to turn the lights on. Then,
depress the switch to the down/aft position to turn the lights off.
Instrumentation
Compass
The compass is located on the dash on top of the console. To ensure
that the compass light is working properly, press the Nav/Anc switch in
the forward position to turn on the red LED light inside the compass.
When finished, turn the Nav/Anc switch back to the middle position.
Please refer to the owner’s manual provided by the manufacturer of the
compass for operational procedures and for information related to the
care and maintenance of their product. When in doubt, always defer to
the compass manufacturer’s instructions and/or recommendations.
Horn - Electric
The horn is used to signal, warn or alert other boats or persons on shore. The horn switch is located on the
switch panel. The horn device is located on the gunwale at the starboard side of the bow area.
Depress the horn
switch to the up or forward position to activate the horn, then release the horn switch to deactivate the horn.
20
