Pro Lighting e.K., Tannenstr. 9, 85609 Aschheim, Tel. +49 89 9077869-0, www.prolighting.de
•
Carry the unit by the carrying handles - NOT by the body.
•
Do not expose the unit to overheating, moisture or damage during installation. Also do not leave wires
directly on the floor, they may cause an electric shock.
•
Ensure before installation that the installation location is suitable.
•
After installation, secure additionally with a safety cord.
•
Make sure that the lenses are not damaged. If you notice any significant scratches on the lenses, they
should be replaced.
•
Ensure that the person operating the unit is qualified and experienced to do so.
•
Retain the original packaging in case of re-shipment.
•
Do not attempt to carry out repairs yourself. In the event of a fault, contact your distributor or dealer.
•
The manufacturer and distributors are not liable for damage caused by improper use or failure to follow
the instructions in this manual.
6.
INSTALLATION.
WARNING:
For added protection mount the fixtures in areas outside walking
paths, seating areas or in areas were the fixture might be
reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the
installation area can gold a minimum point load of 10 times the
device’s weight. Fixture installation must always be secured with
secondary safety attachment, such as an appropriate safety
cable.
Never stand directly below the device when mounting, removing
or servicing the fixture from a ceiling, or set on a flat level surface
(see illustration). Be sure this fixture is kept at least 0.5 m (1.5 ft)
away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety
measure to prevent accidental damage and/or injury in the event
the clamps fails.
Mounting points:
Overhead mounting requires extensive experience including amongst other calculating working load limits, a fine
knowledge if the installation material being used, and periodic safety inspection of all installation material and the
fixture. If you lack these qualifications, do not attempt the installation yourself. Improper installation can result in
bodily injury. Be sure to complete all rigging and installation procedures before connecting the main power cord to
the appropriate wall outlet.
Clamp mounting:
Frame Par 7x12 provides a unique mounting bracket assembly that integrates the bottoms of the base, and the
safety cable rigging point in one unite (see illustration). When mounting this fixture to truss be sure to secure an
appropriately rated clamps to the included omega bracket using a M10 screw fitted through the center hole of the
handle. As an added safety measure be sure to attached at least on properly rated safety cable to the fixture
using on of the safety cable rigging point integrated in the base assembly.