PRO Light V200LED, User Manual

Page: 39 / 44

17
V200LED
3.19 REMOTE CONTROL EC800 (optional)
The remote control EC800 (Pic. 2) available as an accessory allows to control different functions.
1. Connect the remote control to the jack ONLY FOR REMOTE CONTROL.
2. No DMX signal must be present at the DMX IN(10). The yellow LED MASTER must lights up.
3. Via the DMX OUT, it is possible to connect further units in order to control them via the remote control
together with the master unit.
4. With the STANDBY button, the sleep mode can be switched on and off. With the sleep mode switched on, the LED
next to the button will light up. The pan head will go to its starting position and the light beam will be switched off.
5. With the MODE button, select the operating mode:
• Stroboscope mode SOUND1 (LED next to the MODE button does not light up). Each time the FUNC-
TION button is kept pressed, the unit changes to the next of the three stroboscopic effects:
- stroboscope independent of the music, in sync with the slave units;
- stroboscope independent of the music, alternating with the slave units;
- stroboscope depending on the music.
After releasing the FUNCTION button, the show program will be reactivated.
• Show mode (LED flashing). Select the desired show program (Show 1 to 4) with the FUNCTION button.
• Selection of the transition speed (LED lights continuosly).
In this operating mode, the colors will change automatically by transition from one color to another.
Any music played at this stage will not affect this mode. A selection of three transition speeds is avail-
able when the FUNCTION button is pressed repeatedly.
Pic. 6 Pic. 5
4.1 CLEANING THE UNIT AND MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during set-up.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any deformation.
• When the lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• In order to protect the device from overheating the cooling fans (if any), and ventilation openings should
be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• It is recommended to clean the plastic panel of the unit at regular intervals, from impurities caused by
dust, smoke, or other particles to ensure that the light is radiated at maximum brightness. For cleaning,
disconnect the main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then
carefully wipe the plastic pane dry. For cleaning other housing parts use only a soft, clean cloth. Never
use a liquid, it might penetrate the unit and cause damage to it.
Warning: we strongly recommend internal cleaning to be carried out by qualified personnel!
4.2 CHANGING THE LENSES
V200LED is provided with a projection angle of 25°. By changing the lens it is possible to obtain projection
angles with 15° and 45° (optional lenses). The procedure is described as follows on pic.5 and pic.6.
- 4 - MAINTENANCE