2
Save these instructions.
For your
safety, read, understand, and follow the
information provided with and on this
jack. The owner and operator of this
equipment shall have an understanding
of this jack and safe operating procedures
before attempting to use. The owner and
operator shall be aware that use and
repair of this product may require special
skills and knowledge. Instructions and
safety information shall be conveyed in
the operator’s native language before
use of this jack is authorized. If any doubt
exists as to the safe and proper use of this
jack, remove from service immediately.
Inspect before each use.
Do not use if
broken, bent, cracked, or damaged parts
(including labels) are noted. Any jack that
appears damaged in any way, operates
abnormally or is missing parts, shall be
removed from service immediately. If
the jack has been, or suspected to have
been subjected to a shock load (a load
dropped suddenly, unexpectedly upon
it), immediately discontinue use until jack
has been checked by a factory authorized
service center. It is recommended that an
annual inspection be done by qualified
personnel. Labels and Owner’s Manuals
are available from the manufacturer (see
Replacement Parts, page 6).
PRODUCT DESCRIPTION
Pro-Lift Floor Jack is designed to lift, but
not sustain, rated capacity loads. It is
designed to be used in conjunction with
jack stands. Pro-Lift Floor Jack has a
unique feature which provides fast, no
load lifts to the jacking point.
Intended
use:
To lift one wheel or axle of a vehicle
for the purpose of service and/or repair
of vehicle components. After lifting, loads
must be immediately supported by a pair
of appropriately rated jack stands. Check
with vehicle owner’s manual for proper
lift points.
BEFORE USE
1. Verify that the product and the
application are compatible, if in doubt
call
Pro-Lift Customer Support @
(888) 332-6419.
2. Before using this product, read the
owner’s manual completely and
familiarize yourself thoroughly with the
product, its components and recognize
the hazards associated with its use.
3. Using the stamped end of the provided
handle, engage and turn the release
valve counterclockwise no more
than 1/2 full turns from a fully closed
position.
4. With saddle fully lowered, locate and
remove the oil filler plug. Insert the
handle into the handle sleeve, then
pump 6 to 8 full strokes. This will help
release any pressurized air which may
be trapped within the reservoir. Oil
level should be ~3/16” above the inner
cylinder as seen from the oil filler plug
hole. Reinstall the oil filler plug.
5. Check to ensure that jack rolls freely
(if so equipped) and that the pump
operates smoothly before putting into
service. Replace worn or damaged
parts and assemblies with factory
Authorized Replacement Parts only.
(See Replacement Parts Section).
Lubricate as instructed in Maintenance
Section.
2 Ton Floor Jack
