Pro-face FP-3710K Series, User Manual

Page: 60 / 104

Chapter 6 Setting up and Adjusting the FP unit
6-3
The factory default for the FP unit’s Dip Switches and Slide Switch are as follows.
„
SW1
• SW1-2
Dip Switch SW1-2 is used to display or hide the OSD.
To hide the OSD, set the switch to ON. To display the OSD, set the switch to OFF.
The default setting is OFF. (OSD is displayed.)
„
SW2
• Slide Switch is used to switch the data input/output (command control) method on the touch panel
between USB and RS-232C.
The default setting is USB.
6.1.2 Status of Front LED in Operation Modes
• Only the settings when the power supply is turned on is effective to the Dip
Switches and the Slide Switch. After changing the settings of the Dip Switches
and the Slide Switch, be sure to restart your FP unit.
SW1-1 Reserved (Always OFF)
SW1-2 Display/Hide the OSD
SW1-3 Reserved (Always OFF)
SW1-4 Reserved (Always OFF)
SW1-5 Reserved (Always OFF)
SW1-6 Reserved (Always OFF)
SW1-7 Reserved (Always OFF)
SW1-8 Reserved (Always OFF)
LED OFF Green Orange Green/Red Flash Orange Flash
*1
*1 Only while “No signal” is displayed.
Panel Power OFF Power ON Power ON Power ON Power ON
Backlight - Normal Normal Burned-out Burned-out
Input of Image - Yes No Yes No
1 2 3 4 5 6 7 8
ON
23
2
USB