Pro-face FP-3710K Series, User Manual

Page: 54 / 104

Chapter 5 Installation and Wiring
5-9
(4) After inserting all three pins, insert the Power Plug into the Power Connector at FP. Fix the plug with
two(2) minus screws.
5.2.2 The USB Cable Clamp
„
How to use the USB cable clamp
‹
USB Cable Clamp Attachment Procedure
(1) Connect the USB cable to the connector.
(2) Insert the cable clamp into the cable clamp holder as shown in figure 1, and tighten the clamp until the
cable is secured in place.
‹
USB Cable Clamp Removal Procedure
(1) Push in the cable clamp’s stopper until the cable clamp is unlocked, then remove the clamp.
(2) Disconnect the USB cable.
• Confirm that all wires are connected correctly.
• The torque required to tighten these screws is 0.5 N•m - 0.6 N•m.
• To prevent the possibility of a terminal short, use a pin terminal that has an
insulating sleeve.
USB Cable
Stopper
USB cable clamp holder
USB cable clamp
Figure 1