P15972 Deflector Shield Installation
Hold the ends of the deflector open slightly to clear the spreader
frame in the back. Hang the deflector onto the spreader bumper bar.
Align the slots in the back of deflector with the top frame bolts
and secure both sides of the deflector with washers
and wing nuts. To remove, simply loosen the wing nuts,
spread the deflector slightly to clear the frame, and slide
the deflector off. Retighten wing nuts.
WASH
Never store material in spreader. Return unused
product to its original container.
Wash spreader thoroughly after each use and dry
completely in the sun or heated area.
Grease axle bearings on the frame. Oil the impeller
shaft bearing in hopper, pivot points on the shut-off
linkage and the spring in the housing under the rate plate.
Remove the gear cover and wash gears thoroughly
and oil all bearing areas as shown. Re-install gear cover.
Gear mesh should be checked on a regular basis
during high use periods. Clearance between the axle
gear and pinion gear should be minimal but not tight. If
adjustment is necessary, loosen axle collar set screw
and hold the gears together. Slide the axle collar against
gear support and tighten axle collar set screw. Spin drive
wheel. Gears should run freely and smoothly.
Impeller surface should be cleaned periodically to
remove build-up of product. Build-up can cause the
spread pattern to change.
Tire pressure should be 20-25 PSI
1.
2.
4.
3.
5.
7.
6.
OIL
AXLE COLLAR
GREASE
GREASE
OIL
OIL
HOPPER
BEARING
WASH & DRY
THOROUGHLY
OPTIONAL ACCESSORIES
for
CBR
-
iv
&
CBR
-
ivss
MAINTENANCE
