Page:
12
Rev:
04.2014
A
‐
205
‐
Owner’s
Manual
Assembly Instructions:
13. Connect all the cables to the control box as shown in the picture below.
A. Connect the Hand Control connector to the large circle on the left side of the control box as shown in
the Figure 20.
B. Connect the Up/down Actuator Cable connector to the second circle (Marked No. 1) from the left side
of the control box as shown in the Figure 21.
C. Connect the Leg Spreading Actuator Cable connector to the third circle (Marked No. 2) from the left
side of the control box as shown in the Figure 22.
D. Connect the Mains Cable/Power Cord to the rectangular outlet on the control box as shown in the Figure
23.
14.
Please make sure to charge battery before initial use and before each operation of mobile hoist.
Figure 20
Figure 21
Figure 22
Figure 23
232
After assembly, check to ensure that:
1. Lifting actuator moving up and down with the buttons on the hand control, and control box.
2. Emergency lowering (mechanical, and electrical) functions works properly.
3. Rear wheel brakes works properly.
4. Leg spreading actuator works properly.
5. Batteries are fully charged.
