Prior Scientific OptiScan II ES107, Operating Instructions Manual

Page: 63 / 94

60
Prior Scientific
Set up and run HyperTerminal (Windows Users) see Appendix C.
Try several basic commands while in HyperTerminal to determine if the stage responds
correctly, if so the controller is functioning properly. At this point consult the supplier of the
Image Analysis Software. If the stage does not respond to the commands, contact your local
Prior dealer for further advice.
Note: Before running commands using HyperTerminal make sure that your
microscope objectives and any other objects that may impede the motion of
the stage are moved out of the way, to avoid damage.
Problem
System will not respond to remote RS232 commands
Suggestions:
Set Up HyperTerminal (see Appendix C). Check that the RS232 cable is plugged into the
RS232-1 port in the back panel of the OptiScan II Controller. Press “Enter” on your
computer keyboard several times. If the “TX” and “RX” lights on the front of the controller
blink and the system does not respond, then there is an internal problem with the controller.
Return the unit to your local Prior Dealer.
If the “TX” and “RX” lights do not blink on and off, then there is a problem with the
computer sending the commands.
Problem:
My stage will execute the first command sent, but for each subsequent command the
controller returns an error message “E, 5”.
Suggestions:
Make sure that your computer is not sending an extra line feed command at the end of each
command being sent. If you are using HyperTerminal, check that the set up is correct using
Appendix C.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com