Prior Scientific OptiScan II ES107, Operating Instructions Manual

Page: 46 / 94

OptiScan II ™
43
H None 0 Turns OFF the joystick (Stage and Z axes) after completion of
any current joystick move. Joystick is re-enabled using ‘J’
Command below. The joystick is re-enabled each time the
controller is powered up.
I None R Gracefully stops movement and returns to the position the
interrupt was entered at.
In compatibility mode only
there
is no need for a <CR>. The command Queue is also emptied.
J None 0 Turns ON the joystick. (Stage and Z axes) This command is
acted upon immediately.
JZD d 0 Sets the direction of Z axis under digipot control,
d=1 or d=-1.
JZD None d Reads d.
K None R Stops movement with no regard for position (Not
recommended) . This command is acted on immediately in
compatibility mode there is no need for a <CR>. The
command Queue is also emptied.
M None R Moves stage and focus to zero ( 0,0,0 )
OF s 0 Sets the speed of the focus motor under joystick/digipot control.
s is percentage in range 4 to 100.
OF None s Reports value of OF allowing for joystick speed buttons effect (if
the button speed is ½ and OF is set to 50 the returned value
will be 25)
PZ None z Reports position of z only.
PZ z 0 Sets Absolute position of z axis, No axis can be moving for this
command to work. If encoder on Z the position is only set
when the current position is in the encoder range (it must have
been further down than it is currently).
SAZ a 0 Sets the current Z acceleration to a. Range is 4 to 100
SAZ None a Report the current Z acceleration setting.
SMZ None m Report the current Z maximum speed setting m
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com