254764-001 Rev B 33
~LC##
Minimum number of symbol characters to decode in an Interleaved 2 of 5 symbol.
This command sets the minimum number of symbol characters to be expected (## in the command, 01-16)
by the Interleaved 2 of 5 decoder. This adds extra filtering in applications where I 2 of 5 symbols are used
and there is a large amount of other graphics such as fonts in the scan path. Example: ~LC03 sets the unit
to decode I 2 of 5 symbols (assuming the I 2 of 5 decoder is enabled) containing three or more symbol
characters.
Note: each I 2 of 5 symbol character contains two data digits, therefore the symbol in the
example must contain a minimum of six data digits to be decoded.
~LD##
Passing percent decode.
This command sets the % decode threshold for a passing condition. If analyzing poorly printed symbols, it
is recommended that partial decodes be enabled at the decoder level when this command is enabled.
xx = failure threshold. Example ~LD75: if 74 % or less of scans on a code were not fully decoded, this sets
a failure for this parameter.
~LE#
Exclude the Specified Symbology for a Label:
(‘
#
’ identifies the excluded symbology:
# =
1(UPC/EAN)
2(Code 39)
3(Code 128)
4(Interleaved 2 of 5)
5(Code 93)
6(Codabar.)
~LFxy
Analyze special subsymbology parameters
This command enables special subsymbology parameters within a symbology. This does not affect the
automatic calculations and analyses for mandatory symbology check digits such as those required in Code
128, UPC/EAN and Code 93.
x = symbology type
1(UPC/EAN)
2(Code 39)
3(Code 128)
4(Interleaved 2 of 5)
5(Code 93)
6(Codabar.)
y = subsymbology choice for a particular symbology. Current choices include:
0
=
disabled
(default
condition)
1 = Mod 10 check digit for Interleaved 2 of 5
Note: additional subsymbology choices will be added as applications require. Contact PRINTRONIX for
details.
Example: ~LF41 = check mod 10 check digit in last location for any I 2 of 5 symbol analyzed
~LF40 = disable any subsymbology analysis for I 2 of 5 symbols
~LI#
Include the Specified Symbology for a Label:
‘
#
’ identifies the included symbology:
# =
1(UPC/EAN)
2(Code 39)
3(Code 128)
4(Interleaved 2 of 5)
5(Code 93)
6(Codabar.)