6
•
SAVE THESE INSTRUCTIONS.
PRINCESS TIPS
•
FOR HOUSEHOLD USE ONLY.
• Do not yank on any cord to disconnect.
• Never plug appliance in where water floods the area.
• Place the appliance on a firm and stable surface.
• Ensure that the appliance is not placed so close to the edge of the table, worktop, etc. that it may
be knocked off. Remember that the kettle is filled with hot water.
• Never immerse the appliance in water or in any other liquid.
• Do not use any abrasive or scouring cleaning agents.
• Do not use the equipment if it is damaged, or if the lead is damaged. Sent it to our Service
Department to avoid a hazard. With this type of appliance, a damaged cord should only be
replaced by our Service Department using special tools.
CLEANING
FIRST UNPLUG THE APPLIANCE AND LET THE CAN COOL DOWN!
The outside can be wiped with a damp cloth. A dry cloth should always be used to clean the base.
DESCALING
Use a descaling agent that is suitable for domestic appliances such as coffee–makers. Use the agent
according to the instructions on the packaging. Do not switch the can on when descaling, but allow
the agent to soak in when cold. Rinse the can several times with clean water after descaling.
BEFORE USE
Read these instructions fully before use and keep them for future reference. Check whether the
mains voltage in your home corresponds to that of the appliance. Use only an earthed socket for this
appliance.
The cordless kettle will bring a maximum of 1,5 litre of water to the boil in a few minutes. The can
is extremely convenient to use, as it can be removed from the base. It has a safety lock on the lid, a
pilot lamp, a thermostat and a boiling–dry protection.
Place the PRINCESS MIRROR KETTLE on a stable, firm table or worktop so that the appliance
cannot be easily knocked over.
USING THE KETTLE
The kettle should only be used for boiling water and is not suitable for boiling other liquids or for
other ingredients. First boil a full can of water to clean the can. Throw this water away.
Always fill the can to a point between the minimum and maximum indication marks.
If the water level is too low the can will switch off too early, whereas if the water
level is too high the water will boil over. When filling the can, always remove it from
the base to avoid spilling water on the base.
Switch the can on by pressing the on–off switch under the handle. The pilot lamp will
light up. As soon as the water boils, the on–off button will automatically switch to the
“off” position.
