SETTING STOP BLOCKS
(See figures 8 & 9.)
The stop blocks allow toasting different sizes, cuts and
brands of bread product. There are (6) combination
stop block settings in
1
/
16
” increments. The overall
range is
3
/
4
” to 1-
1
/
4
”. The stop block settings allow a
better crush when toasting different styles of buns.
1. Ensure stop blocks are on the correct setting
before operating toaster. There are (6) stop block
combinations available.
2. To change a stop block setting, depress the right
stop block to disengage locking pin and turn in
either direction to the desired setting.
3. View the stop block setting selected through the
index window bracket which is located over each
stop block. See figure 8.
4. Locate the selector lever (A) on the front of the
toaster frame and move the lever left or right to
allow you to switch back and forth between the
combination setting selected on the stop block.
See figure 9.
figure 8
figure 9
CENTER OPENING ADJUSTMENT
To adjust the opening between the upper and lower
platens, loosen the two screws holding the adjust-
ment plate on each side of the lower platen. There
are 11 adjustments. The middle adjustment is
1
/
2
” .
Each adjustment moves the opening
1
/
16
”. Moving
the adjustment plate to the left increases the open-
ing, moving it to the right decreases the opening.
The center adjustment should be used when toast-
ing different cuts of bread.
OPERATION
After selecting a cooking time and temperature, and
setting the stop blocks and the center adjustment
plate you are ready to begin toasting buns.
1. Using the bun spatula place the crowns face up.
2. Using the other bun spatula place the heels cut
face down.
3. Lift the bun board on the upper platen up and insert
the spatula with the heels on it.
4. Lower bun board down on top of heels and spatula
slide spatula out leaving heels on platen with bun
board on top.
5. Insert spatula with crowns on it into he center
section or lower section of toaster.
6. Pull toaster handle forward to move platen on top of
crowns, the timer will automatically activate and
the red timer light will come on.
7. When the audio alarm sounds and the bun done
light comes on, immediately push handle back to
release crowns from platen. Remove spatula with
crowns from toaster.
8. Lift bun board on upper platen and slide the spatula
in under the heels and remove
4
Summary of Contents for Excalibur 411-SL Series
Page 12: ...WIRING DIAGRAM 12...
