Primex OneVue Levo Series, Install Manual

Page: 26 / 40

Assemble remote antenna
1. For vertical mount, connect the BNC cable adapter to the straight connector. For horizontal mount, remove the
straight connector and connect the BNC cable adapter to right-angle connector. Push the adapter onto the
connector and turn connector 1/4 turn to lock into place.
NOTE
Antenna is required to be in a vertical position.
2. Connect the antenna to the other end of connector.
3. Use the two screws to securely mount bracket to wall surface.
Mount remote antenna
• The length of the BNC cable can be increased by adding cables and adapters up to a maximum recommended length
of 45 ft. (13.7 meter). The cable can be placed in any position, but the antenna must be mounted vertically and away
from metal objects. Unless it is very close to the Transmitter, the powered clock will not set to the correct time
without the remote antenna connected.
• If the remote antenna is to be mounted above the clock and if the antenna cable is to be concealed behind the wall,
use a single gang electrical box to be mounted horizontally behind the clock. For a straight vertical cable run, a
minimum of 0.5 inch (1.27 cm) electrical conduit should be used, coupled with the top side of the electrical box.
• If a 16.5 ft. (5 meter) cable extension is used and the intent is to keep as much cable concealed as possible, connect
the extension to the standard antenna cable prior to running the cable into the conduit.
• For a concealed cable run, a 0.5 inch (1.27 cm) hole in the wall will need to be made close to where the remote
antenna bracket will be mounted. The antenna cable BNC plug has a straight vertical mate with the remote antenna
bracket.
Page 26