Primex OneVue Levo Series, Install Manual

Page: 23 / 40

2. Connect conduit connection(s) to the junction box.
NOTE
For timer models only, AC wiring is required to be located to the right side of the junction box
divider and the timer input to the left side.
3. New Wall Surface only: cut out a 14 in. (35.5 cm) wide x 5.25 in. (13.3 cm) high wall opening for placement of the
clock assembly. Trim opening if necessary.
4. Gently snap the Flush Mount bezel onto the front of the clock/timer.
5. Secure wiring and complete AC power. For a timer model, connect the timer inputs.
6. Insert clock assembly into the wall opening.
7. Level clock assembly within wall opening and secure bezel to the wall surface using the four screws and anchors
(supplied) at each of the corner locations.
Upon applying power to the digital clock/timer or when pressing the Reset button located in the setting panel, the clock
initiates its power up sequence as described below.
1. All 8 LED segments display 8’s with a red dot on the bottom right of each of the two hour digits and one at the
second or last minute digit.
Page 23