Set display settings
Levo Digital Clocks and Timers have a dip switch control panel that sets its display settings. To change the factory
default settings, from the back side of the clock remove the small rectangular access panel. Setting changes can be
made while the clock/timer is ON and changes will take effect within a few seconds.
NOTE
When power is first applied to the clock/timer or the reset button is pushed, a decimal point will flash for
approximately three minutes while its receiver is turned on to search for a Transmitter signal. If the
clock does not receive valid time data from the Transmitter for 3 days, the red colon on the clock will
flash.
Set LED dimmer display
The LED display is set to 100% by factory default.
To dim the LED by 25%, set the OPTIONS, DIM switch 1 to the OFF position and DIM switch 2 to the ON position, as
illustrated below.
To dim the LED by 50%, set the OPTIONS, DIM switch 1 to the ON position and DIM switch 2 to the OFF position, as
illustrated below.
Page 11
Summary of Contents for OneVue Levo Series
Page 10: ...Page 10...
Page 15: ...Page 15...
