42
Printing from a Mac
Set the Stock Sensor Mode
The stock sensor mode refers to the method the printer will use
to detect the print starting position for each label. To access the
Stock Sensor Mode, click on the Alignment button, then select
Stock Sensor Mode.
Important Note:
Set the Stock Sensor Mode
BEFORE
loading label stock!
You must also set the Stock Sensor Position (Section 2C) so that the
sensor is sensing the correct point on the label stock.
Die Cut (Default).
If you are using standard die-cut labels that
look similar to the graphic use this setting regardless of the size
of the label. Also, use this setting for through-hole label
material where a hold is punched through each label or a notch
is cut on the side.
Reflective.
Use Reflective for label material where a black pre-
printed line (black mark) on the back of the label stock
indicated the break between labels. Black marks are required
on clear label stock rolls, or labels where the label waste matrix
(waste) is left on the liner. Black marks can also be used for
irregular shaped labels, circles larger than 4.6 inches or on any
stock where the print starting position can not be sensed using
the label itself.
INDEX
TOC
