Label Stock 7
2. Lower the Roll Guide and pull it outward to make room for your label stock.
3. Remove any shipping tape from your label stock roll to ensure that it can unroll freely,
making certain that no adhesive portion is exposed. It is important to note that any
exposed adhesive surface can attach itself the inner workings of the print mechanism
and cause a media jam.
4. Place your roll of label stock on the Roll Arm and push it inward until it touches the
Roll Stop.
5. Flip up the Roll Guide and slide it inward until it touches the label stock. The Roll
Guide will automatically pull back slightly to the correct position. There should be
approximately a 1.0mm (0.040") gap between the roll guide and the roll.
Important Note:
Be aware that some label stock may have a core that is slightly too large for the roll or
the labels may have wrapped unevenly causing some to stick out beyond the edge of the core.
Both of these issues can cause feeding problems.
Do Not Pinch!
Roll Arm
Roll Stop
Roll Guide
