Primera FX400e, User Manual

Page: 13 / 30

E. LOADING THE LABELS (INTERNAL)
1. Place the lable stock onto the small lable spindle. If your paper
core is between 1,5” and 2,95“, use the 1.5” core adapters on the
small label spindle.
2. Open the printer’s top cover by releasing the top cover open
levers located on each side of the printer and lifting the top
cover. A top cover support at the rear of the printer will hold the
printer top cover open.
3. Place the label spindel onto the internal label roll mount.
4. Feed the paper, printing side face up, through the teflon bar,
paper guide and pass over the platen.
5. Adjust the green center-biased paper guides in or out so they
are slightly touch the edges of the label backing.
6. Lift up the top cover to the ultimate angle then close the top
cover gently and it will be kept at a stop position between 1 and
2 for a while. Use both hands to gently push down the top cover
to close it and make sure the cover is latched on both sides.
Note: 1. Please calibrate the gap/black mark sensor when changing
media.
2. Failure to securely close and lock the cover will result in poor
print quality.
Paper Roll
1” Label Spindle
Printing Side
Face Up
1.5” Core Adapter
Top Cover Open Lever
Teflon Bar
Internal Label
Roll Mount
Printer Top Cover
Top Cover Support
Center-based
Paper Guides
Hardware and Software Setup
9