Primera FX400e, User Manual

Page: 12 / 30

D. LOADING THE LABELS (EXTERNAL)
1. Place the printer onto the two pegs of the external label roll
mount.
2. Depending on the inner diameter of the paper core of the label
stock, take the apropriate label spindle and insert it into the
paper roll. If your paper core is between 1,5” and 2,95“, use the
1.5” core adapters to hold the . If your paper core is 2,95“ or
wider use the external lable spindle.
3. Place the label spindel onto the external label roll mount.
4. Feed the end of the label stock into the external lable feed
opening at the back of the printer.
4. Open the printer’s top cover by releasing the top cover open
levers located on each side of the printer and lifting the top
cover. A top cover support at the rear of the printer will hold the
printer top cover open.
5. Feed the paper, printing side face up, through the teflon bar,
paper guide and pass over the platen.
6. Adjust the rear and the center-biased paper guides in or out so
they are slightly touch the edges of the label backing.
7. Lift up the top cover to the ultimate angle then close the top
8. Use the “Diagnostic tool” to set the media sensor type and cali-
brate the selected sensor. (See Section 2F. )
Note: 1. Please calibrate the gap/black mark sensor when changing
media.
2. Failure to securely close and lock the cover will result in poor
print quality.
Paper Roll
1” Label Spindle
Printing Side
Face Up
1.5” Core Adapter
Top Cover Open Lever
Teflon Bar
External Label
Roll Mount Printer Top Cover
Top Cover Support
Center-biased
Paper Guides
8
Hardware and Software Setup
Rear Paper
Guides