Z-Chair
www.pridemobility.com
23
V . C O M F O R T A D J U S T M E N T S
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your Z-Chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the hardware from the footplatform bracket.
See figure 19.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket
and tighten.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off or your power
chair. See figure 20.
To rotate the SFRs:
1. Push in the release lever.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the back of
each footrest extension.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Figure 19. Foot Platform Depth
Figure 18. Armrest Width Adjustment
ARMREST KNOB
(LOCATED ON
SEAT FRAME)
Figure 20. Swing-Away Footrests
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER
