AUS Jazzy 1103 Rev E/Sep02
www.pridemobility.com
27
V I I I . C A R E A N D M A I N T E N A N C E
CLEANING INSTRUCTIONS
n
Never hose off your Jazzy 1103 or place it in direct contact with water.
n
Your Jazzy 1103 has a clear-coated ABS plastic body shroud that allows it to be easily wiped clean with a damp
cloth. Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or dry out
and crack. Use soapy water and dry the seat thoroughly.
TYRES AND TUBES
If your Jazzy 1103 is equipped with pneumatic tyres, you should check the air pressure at least once a week. This
prolongs the life of your tyres as well as helps ensure the perfect operation of your chair. If you have a flat tyre,
replace the tube. Replacement tyres and tubes are readily available at the Pride provider location where you purchased
your Jazzy 1103.
WARNING! Completely deflate the tyre before attempting repair!
Follow these easy steps for a quick and safe tube or tyre replacement:
1. Completely deflate the tyre (if pneumatic).
2. Use a 9/16-in. wrench to remove the nut from wheel axle.
3. Pull the wheel off of the axle.
4. Use a 1/2-in. socket and ratchet to remove the four bolts that hold the two-piece wheel together. The rim
separates into two pieces.
5. Remove the old tube and/or tyre and replace with new tube or tyre.
6. Place the rim halves together and reinstall bolts.
7. Slide the wheel back onto the shaft and torque the nut to 16 ft.-lbs.
8. Inflate the tyre to 30-35 psi (if pneumatic). Do not exceed 35 psi.
BATTERY REPLACEMENT
To replace the battery:
1. Turn the power off.
2. Unplug the controller wire harness. See VII. “Disassembly.”
3. Remove the seat.
4. Remove the body shroud.
5. Engage the motor drive assembly. See V. “Operation.”
6. Remove the 1/2-in. nuts and bolts that fasten the battery cables to the battery.
7. Install the new batteries into the Jazzy 1103 with the terminal sides of the batteries inward facing each other.
8. Connect the wire marked (+) to the closest positive (red) battery terminal.
9. Connect the wire marked (-) to the closest negative (black) battery terminal on the other battery.
10. Connect one circuit breaker harness to the empty positive terminal of one battery and the other circuit breaker
harness to the empty negative terminal of the other battery.
11. Dispose of your old batteries in accordance with your local disposal laws.
