AUS Jazzy 1103 Rev E/Sep02
www.pridemobility.com
21
TURN THIS SCREW TO CHANGE ARMREST ANGLE
JAM NUT
LOCKS
ADJUSTMENT
SCREW IN
PLACE
Figure 8. Armrest Angle
V I . C O M F O R T A D J U S T M E N T S
Figure 7. Armrest Width
Figure 6. Seat Height Adjustment
LOOSEN KNOB TO MOVE ARMREST
HEX HEAD NUT
SEAT
PEDESTAL
BASE
SEAT
PEDESTAL
After you have had your Jazzy for an extended period of time, you
may find the need to adjust the seat. There are some adjustments
you can make to increase your comfort, such as seat height and
armrest angle. If your Jazzy 1103 was configured at your authorised
Pride provider or service center, please consult your health care
professional before changing seat position, or making any other
adjustments. Some of these adjustments may decrease your Jazzy’s
performance and safety by changing its center of gravity.
SEAT HEIGHT
You can change the seat height to one of three positions in 2,5 cm
increments.
To change the seat height:
1. Remove the seat. See VII. “Disassembly.”
2. Remove the shroud.
3. Use two 9/16-in. wrenches to loosen and remove the hex head
nut and bolt. See figure 6.
4. Slide the seat pedestal up or down in the seat pedestal base.
5. Align the holes on the seat pedestal and the seat pedestal base.
6. Reinstall the hex head bolt and tighten.
ARMREST WIDTH ADJUSTMENT
To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See figure 7.
2. Loosen the knobs; slide the armrests in or out for the desired width.
3. Retighten the knobs.
ARMREST ANGLE ADJUSTMENT
You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Use a 7/16-in. wrench to loosen the jam nut. See figure 8.
3. Use a 5/32-in. hex key to loosen the hex nut. Turn the screw
clockwise to raise the front of the armrest and counterclockwise
to lower the front of the armrest.
4. Lock the adjusting screw into place by tightening the jam nut.
ARMREST HEIGHT ADJUSTMENT
Your Jazzy may be equipped with armrests that are adjustable in
2,5 cm increments.
To change the armrest height:
1. Remove the ball detent pin from the armrest.
2. Move the armrest up or down to the desired height.
3. Reinsert the ball detent pin.
