Pride Mobility Go-Go Travel Lift, Owner'S Manual

Page: 13 / 19

13 Go-Go Travel Lift www.pridemobility.com
I I I . I N S T A L L A T I O N
ROUTE RED (+) POWER WIRE
TO BATTERY
BLACK (GROUND) WIRE
ATTACH TO CLEAN, BARE METAL
IN CLOSE PROXIMITY TO LIFT
BLACK - RED
POWER
HARNESSES
AUTOMOBILE
BATTERY
MOTOR HOUSING
Figure 12. Electrical Wiring Connections
SHEET METAL SCREW
12 MM (1/2”)
CONNECTOR
(USE PLIERS OR CRIMPING
TOOL TO CRIMP)
FUSE
25-AMP
4. Connect the short black (ground) wire to a clean, bare metal area of the vehicle using the 12 mm (1/2 in.) sheet
metal screw provided. Mount to an area close to the base of the lift. This allows adequate slack in the wire to
make the harness connections.
"
Drill a 1/16-in. pilot hole where the ground wire will be attached to the vehicle.
"
Insert the screw through the ring at the end of the black (ground) wire and install the screw into the
pilot hole.
WARNING! DO NOT attach the black (ground) wire to the lift.
5. Connect the harness of wires leading to the battery and ground to the harness that extends from the motor
housing (black to black and red to red).