Pride Mobility Go-Go Travel Lift, Owner'S Manual, Page: 8 / 19

8
Go-Go Travel Lift www.pridemobility.com
I I I . I N S T A L L A T I O N
Figure 2. L-Base (Hatchback Installation)
Figure 3. L-Base (Trunk Installation)
WHEEL WELL
Figure 1. L-Base Extensions
BASE EXTENSIONS
NUT
L-BASE
BOLT
38 MM (1.5”)
!
!
The Go-Go Travel Lift can be installed in either side
of your vehicle. The illustrations demonstrate installa-
tion on the right side.
PROHIBITED! Avoid exposure to
rain, snow, ice, salt, or standing
water whenever possible. Maintain
and store in a clean and dry
condition.
NOTE: Most roads have a crown to help with
water runoff. However, if the crown is severe
enough, it may cause difficulty getting your
scooter into the vehicle. In this case it may be
better to install the lift on the left side.
DETERMINE L-BASE LOCATION
1. Assemble the L-Base. See figure 1. For opti-
mal use, insert the base extensions into the L-
base at their farthest extension point and install
the hardware (nuts and bolts). The base exten-
sions can be adjusted to accommodate obstruc-
tions.
NOTE: Always insert the bolt from the inside of
the L-base. This allows the base extensions to
be properly tightened without rattling.
2. Before permanently installing the lift, place the L-
base inside your vehicle in the area in which you
intend to install it. See figure 2 for L-base posi-
tioning in vehicles with hatchbacks, or figure 3
for trunk installation.
Positioning the L-base close to the rear allows the
boom-arm to stay as short as possible; this enables
the boom arm to swing freely without making contact
with the vehicle.
VEHICLES WITH TRUNKS
Position the L-base as shown in figure 3. You may
need to situate the L-base so the wheel well doesn’t
interfere with the L-base extensions. Ensure there is
adequate room for a scooter to comfortably fit into
the trunk.