20
www.pridemobility.com
Blast/Rev F/Feb03
V . A S S E M B L Y
SEAT INSTALLATION
Use the following instructions to assemble your Quantum Blast after unpacking. Refer to figures 1 and 2 and the
Synergy Seat Basic
Operating Instructions
where necessary.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control
of the seat if they do so, resulting in personal injury and/or damage to the power chair.
1. Make sure that the chair is in drive mode. See IV. The Quantum Blast.
2. Remove the ball detent pins from each of the four the seat pin receivers. See figure 8.
3. Place the seat at the desired height.
4. Install the ball detent pins back into the seat receivers.
5. Remove the rear seatback bracket bolts on each side of the seat frame. See figure 8.
6. Recline the seatback to the desired position.
7. Install the two seatback bracket bolts that were removed and tighten.
8. Tighten each of the four seat pin bracket bolts. See figure 1.
9. Install the controller into the armrest that has the controller mounting bracket. See figure 9.
10. Use a hex key to tighten the controller mounting bracket setscrews. See figure 9.
11. Route Remote harness under seat.
CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or the power base
frame.
12. Secure with wire ties.
13. Install batteries. See IX. Care and Maintenance.
14. Charge batteries. See See VII. Batteries and Charging for battery charging details.
BALL DETENT
PIN
SEAT PIN RECEIVER
SEATBACK
BRACKET BOLT
SEAT PIN
BRACKET BOLT
Figure 8. Seat Mounting Detail
(Versa Seat Shown)
Figure 9. Controller Installation
CONTROLLER MOUNTING BRACKET
CONTROLLER MOUNTING BRACKET SETSCREWS
(LOCATED UNDERNEATH)
