TO SET UP WHEELCHAIR
While facing front of wheelchair, open by by placing hands on
seat rails and pushing down and out until seat is open and
level. Attach spreader bar to lock wheelchair in place by lifting
the spreader bar up to adjustment knob and pushing the slot
into place. Then tighten adjustment knob until secure.
Attach Footrests by aligning holes on tabs at top of Footrests
with hinge pins on outside of front frame, then swing Footrests
to front until Footrest Release Levers lock into place.
Adjust Footrest length (while user is seated) by loosening the
cam lever just above the Footplate, pushing in the adjustment
buttons and sliding the inner tubing up or down to desired
setting until the adjustment buttons protrude fully from the
adjustment holes. Then snap cam lever back into place.
Make sure the Footplate is at least 2.5” from the floor for
proper clearance.
TO FOLD WHEELCHAIR FOR STORAGE
Release the spreader bar on the backrest by loosening the
adjustment knob and lowering the bar.
Make sure the Footrests are in the forward locked position
with the Footplates in the vertical position or REMOVE the
Footrests by pulling the Release Levers, swinging the Footrests
outward and lifting them from the hinge pins.
Standing in front of the wheelchair, grab the the seat with both
hands at the front and back and pull up until closed.
OPERATING WHEEL LOCKS
Engage by pushing the levers forward until they lock into place and
disengage by pulling back on the levers until the wheels roll freely.
ADJUSTING ARMS
Remove arms for easy transfer by depressing spring buttons and
lifting out of front and rear sockets.
Reverse arms to provide support while in reclined position.
ADJUSTING ELEVATING LEG RESTS
Lift the Foot Plate to the desired height. The Elevating Leg Rest will
automatically lock into place.
Lower by holding Foot Plate, pushing out on the Release Lever and
lowering the Foot Plate to the desired length.
Engage Release Lever after adjusting to desired length.
RECLINING BACKREST
To recline the backrest, make sure the wheel locks are in the locked
position. Then squeeze both release handles simutaneously and
slowly lower the backrest to the desired position. Release the handles
and the backrest will lock into place.
Clean frame with a damp cloth and dust weekly.
Clean upholstery and armrests with mild soap and
water.
Never use abrasive cleansers or scouring pads.
If exposed to liquid, dry the wheelchair thoroughly as
soon as possible.
If any component appears worn or is not working
properly, contact an authorized dealer for repair
and/or appropriate replacement parts.
Solid rubber tires need minimal maintenance, but
should be cleaned occasionally with a damp cloth.
If tires become severely worn or cracking appears,
contact an authorized dealer.
Wheels and Casters should be checked periodically
and adjusted and lubricated as needed by an autho-
rized dealer.
