Footrest Angle
You can adjust the angle of the footrest with a hex key. See figure 13.
To adjust the footrest angle:
1. Turn the setscrew counterclockwise to raise the front of the footrest.
2. Turn the setscrew clockwise to lower the front of the footrest.
Controller Position
The controller can easily slide out away from the armrest, or in toward the
armrest. You can also move the controller to the other armrest. See figure 14.
To extend the controller:
1. Use a hex key to loosen the setscrew.
2. Slide the controller into or out of the armrest to the desired position.
3. Tighten the setscrew.
You can position the controller for either left-hand or right-hand use.
To change the controller position:
1. Unplug the controller connector from the electronics tray. See figure 4.
2. Cut the wire tie that attaches the controller cable to the armrest.
3. Use a hex key to loosen the setscrew under the armrest. See figure 14.
4. Slide the controller out of the armrest.
5. Loosen the setscrew under the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew.
8. Use a wire tie to secure the controller cable to the armrest.
9. Plug in the controller connector to the electronics tray.
Swing-away Footrests
Swing-away Footrests enable you to rotate the leg rests to the side before
you transfer on or off your Blast.
To move the SFRs:
1. Push in the release lever. See figure 15.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two screws from the side of each leg rest extension. See
figure 17.
2. Slide the leg rest in or out to the desired length.
3. Reinstall the two screws and tighten.
V I . C O M F O R T A D J U S T M E N T
Figure 14. Underside of Armrest
SETSCREW
Figure 15. Swing-Away Footrests
SFR RELEASE LEVER
