FAN FILTER UNIT
INSTALLATION INSTRUCTIONS
Module Installation
The Price FFU will come completely assembled from the factory with the exception of the HEPA/ULPA filters, which will ship in its
own carton, and the speed controller wall kits (if selected).
Sample line string for Room Side Replaceable filter:
FFU-1-4//I/SUPPLY/24/48//
RSR
/HEPA/FC/ECM/115/CF/R+TMB/FL+ML+BACnet/BFC/TC/DSW-115//ASSP///WPF/PL-AL/F-AL/
PL-B12/F-B12
Step 1:
Remove FFU from shipping carton and inspect for any damage.
Step 2:
If unit is Bench Top Replaceable (BTR) install the filter, refer to the filter installation section of this manual for instructions. If
unit is Room Side Replaceable (RSR), proceed directly to next step.
Sample line string for Bench Top Replaceable filter:
FFU-1-X//I/SUPPLY/24/48//
BTR
/HEPA/FC/ECM/115/CF/TMB//ECMSC/TC/DSW-115//ASSP///WPF/PL-AL/F-EM/PL-WM/F-EM
Step 3:
Raise the unit through the ceiling grid at an angle until entire unit is above the grid
Step 4:
Lower unit onto the backside of the tees.
Step 5:
Secure the unit to the overhead structure using the eyebolts located on the back of the unit.
Step 6:
Adjust and level the unit so that it rests on the tees and there is adequate compression on the gasket to warrant a tight
seal.
Ensure that ceiling grid is properly gasket/sealed to prevent infiltration of unfiltered air from the ceiling plenum into the room side.
Above steps are manufacturer's suggested hanging techniques, always make sure to follow all local building codes, including
seismic where applicable.
UNIT EYEBOLTS FOR MOUNTING
3
priceindustries.com | FAN FILTER UNIT - Manual
priceindustries.com | FAN FILTER UNIT - Manual
