CONTROLS/INSTRUMENTS
2 - 24
The manufacturer's code appears:
• On your owner's wallet card
• Taped to the microprocessor/relay module in
driver's A/C compartment
• Three stickers are joined to you owner's
wallet card
When you use the keyless entry system, the
keyboard and stepwell lights illuminate. Do not
push the buttons with a key, pencil or any other
hard object as it could damage buttons. Although
each button is provided with two digits separated
by a vertical line, there is only one contact per
button. Press in center of button, i.e. between
the two digits where there is a vertical line.
You must unlock the entrance door before you
unlock any other baggage or service compart-
ment doors. If you let more than five seconds
pass between the numbers you press, the sys-
tem shuts down, and you have to enter your
code again. If the keyless entry system does not
work properly, use the key to lock or unlock en-
trance or compartment doors.
Keyless Operating Instructions
1. To unlock the entrance door, enter the five
numbers of the code. After pressing the fifth
number, the door will unlock. At night, press
any button to illuminate the keyboard, then
enter the code.
Upon pressing any button, the keyboard will light
up for five seconds and the stepwell lights for
twenty-five seconds.
2. To unlock the baggage and service compart-
ment doors, press button 3/4, within five
seconds after entering the entrance door
unlocking code.
3. To lock entrance door and compartments
simultaneously, press buttons 7/8 and 9/0 at
the same time.
Programming Your Personal Code
Note:
To avoid erasing code from system
memory, you should connect keyless entry sys-
tem to house batteries, otherwise code will be
erased each time battery main disconnect
switches are set to the
OFF
position.
You can program a personal code to unlock en-
trance door and compartments. This code does
not replace the permanent code that is pro-
grammed into the system. Use your personal
code in the same manner that you would use the
original code.
Do not choose a code that presents the numbers
in sequential order, such as 1/2, 3/4, 5/6, 7/8,
9/0. Studies shows that people who idly press
the buttons usually press in a sequential pattern.
Also, do not select a code that uses the same
button five times. Thieves can easily figure out
these types of codes.
1. Choose and memorize your personal code.
2. Enter the original code, and within five
seconds press button 1/2.
3. Within five seconds of pressing button 1/2,
enter your personal code, pressing each
button within five seconds of the previous
digit. The keyboard light will immediately turn
off if code is correctly entered.
The keyless entry system registers your personal
code. To unlock entrance door, you can use ei-
ther code.
4. To erase your personal code, enter the
original code, press button 1/2, then wait six
seconds.
Exterior Compartment Door Lock
Push up rocker switch to unlock the baggage,
entrance and front service compartment door
locks or push down to lock.
Entrance Door Unlocking Switch
Push down rocker switch to unlock only the en-
trance door. This switch can not be used to lock it.
