CONTROLS/INSTRUMENTS
2 - 23
Mirrors
Exterior Mirrors
The vehicle is equipped with two exterior mirrors
which are provided with an electric heating sys-
tem to ensure a good visibility in extreme
weather conditions. Integral thermostats are in-
stalled in both mirrors to avoid continual heating.
Use the appropriate switch on the L.H. dash-
board panel to activate the defroster system on
both mirrors simultaneously.
The mirrors can be electrically adjusted by
means of the switch on the L.H. dashboard con-
trol panel.
Note:
Adjust exterior and interior mirrors before
driving and after adjusting your seat to the
proper driving position. It is important for safe
driving that you have a good reach vision on
each side of the vehicle.
Caution:
Do not install a convex mirror on the
heated mirror glass. This prevents even distribu-
tion of heat in the heated mirror and could cause
the glass to break.
Interior Mirrors
The driver's area is also equipped with two addi-
tional interior mirrors. The first mirror is located
in the upper L.H. corner and is used to see out-
side by the front R.H. window, i.e. a dead angle
without a mirror. The other mirror is in the upper
center of your vehicle and enables the driver to
see inside of the vehicle.
Entrance Door
Inside Operation
There are three ways of unlocking the entrance
door from the inside. The two first consist in ac-
tuating the rocker switch on the lower R.H. side
control panel or on L.H. side control panel, but
this last operation will also unlock the baggage
compartments. Finally, you can unlock door by
sliding its lock lever to the left. If the orange tab
on the door lock lever is visible, the door is un-
locked.
18187
Outside Operation
The first way of locking/unlocking the entrance
door from the outside is by using the door lock
key provided with the vehicle. Turn key to the left
to lock or to the right to unlock the entrance
door.
18188
Keyless Entry System
By this system, you can lock or unlock the en-
trance door and the baggage and service com-
partment doors. The keyboard is located below
the outside entrance door handle. The micro-
processor/relay module is pre-programmed by
the manufacturer and this code can not be de-
leted. Moreover, you can program your own en-
try code (e.g. a birthday or part of a social secu-
rity number).
