7
Check the 'End Float' again,
using above procedure, and
adjust if outside specified limits.
FIGURE 6: TO ADJUST HUB 'END FLOAT'
10021
10.
Clean hub cap and hub mating faces (3
& 8, Fig. 8) with Loctite Superclean
Safety Solvent no. 706 or other suitable
chlorinated solvent then apply a
complete 1/8 inch bead of Loctite
Superflex (black) around mating face of
hub cap (3, Fig. 8). See figure 7.
FIGURE 7: HUB CAP AND HUB MATING FACES
10022
12.
Fit hub cap along (3, Fig. 8) within 5
minutes of applying sealant then secure
with hub cap setscrews and washers (1
& 2, Fig. 8) tightening setscrews to 85-
103 lbf•ft (115-140 N•m).
13.
Fill the oil lubricated oil cap. See
paragraph "1. LUBRICATION" of this
manual.
