Page 8
— OWNER’S MANUAL: TT & WT and ECOA HTT & HUE Series
WARNING!
Do not perform any repair work on a lift in a fully
extended position. Unload lift prior to working
under or around.
All personnel must stand clear of the lift when the
lift is in motion.
Do not put hands or feet under lift.
Do not work under lift without securing it first with
proper maintenance devices.
Do not stand, sit or climb on the lift at any time.
Do not use the lift on soft, uneven or unstable
surfaces.
Do not exceed the load capacity rating on the data
plate.
Do not place a load on a moving lift.
Place a load in the center of the lift and be sure
that the load is secured properly.
S E C T I O N 3
INSTALLATION
A. INSPECTION
Upon receipt of the tilters, inspect the equipment completely
to determine if there is any shipment damage and that the
tilter is complete.
Do not
use the tilter if there appears to be
any damage. With the tilter in a collapsed position, check
the following:
1. Check for signs of damage, especially to the electricals
and hydraulics.
2. Check all connections for tightness. Also check for vis-
ible hydraulic liquid around the connections.
3. Check for any physical damage to the frame.
4. Inspect the platform for damage, either twisted or bent.
B. INSTALLING
Read all of the instructions prior to starting or connecting
the tilter.
1. Working Area
a) Make sure that the floor and the operation area
is flat, stable, relatively smooth and free from dirt,
obstacles and surface defects.
b) Place the empty tilter in the exact operating area
to be sure that there are no encumbrances due to
components or equipment in the general area.
c) Make sure that the complete base of the tilter is in
contact with the floor. In order to complete contact
with the floor, the base may be shimmed or grouted.
d) The tilters are provided with anchoring holes on the
base. Place the tilter in the exact operating position
before spotting and drilling holes for the bolts. Bolt
the lift securely using floor lag bolts with a minimum
of 2000# pull out strength per bolt.
WARNING!
Install the tilter on a solid and stable surface.
CAUTION!
All wiring must conform to local code and must
be performed by licensed electricians. The stan
-
dard AC single phase motor requires a 120 volt
20 amp fused outlet, do not remove or replace
the plug or cord set provided. Do not use an
extension cord.
WARNING!
Do not
tamper with or remove the cover of
the electrical junction box. Only authorized,
qualified personnel should service the electrical
system. Motor direction is critical. This motor
has been wired according to its nameplate and
should not be tampered with as it may lead to
pump or motor failure.
C. HYDRAULICS
1. Before using the tilter, check the hydraulic oil level by
removing the solid plug from the reservoir. Remove the
plug, check for oil and add oil if necessary. See the chart
below for correct oil level. Replace the plug with the
vented plug provided; if the vented plug is not installed
you may damage the pump.
Note:
if a vented plug is
not available, the solid plug may be modified by drilling
a 1/8 diameter hole through the center of the plug and
reinstall.
WARNING!
Do not
use automotive hydraulic brake or trans-
mission fluids, they will damage seals and pose
a serious fire hazard.
