10
Safety and Installation Instructions
UNIT INSTALLATION:
Your Prestige® Pro Series Grill comes pre-assembled and requires very little set-up. We do however
recommend the use of professional help during the installation of your unit as improper installation may
affect your warranty.
Remove the unit from the carton along with all accessories and check that no damage has occurred to
any parts or the unit.
Burners: Check the U shaped burner tubes and remove any obstructions that may be in the ports or
holes. Using cold water and a brush will be sufficient. Make sure all foreign particles are removed from
the burner before use. Make sure the air shutter on the burners is slightly opened to about 1/8".
WARNING
For proper operation, burners must be aligned with the valve orifice and seated in the bracket slot.
This is accomplished by first placing the burner tube shutter hole securely over the valve orifice
and then sliding the burner bracket into the positioning slot. Care should be exercised to maintain
the burner hole/orifice mating assembly.
Igniters: Before placing the flame spreader shields and briquettes in place, make sure the igniter
electrode is positioned 3/16" away from the burner tube and located over the port hole in the burner.
Adjust if necessary.
CONNECTING TO THE GAS SOURCE:
Make sure all of the knobs are in the OFF position.
For Natural Gas Units
Attach a 5/8" flared fitting to the grill and connect to the gas stub with a quick disconnect or threaded
fitting to match the stub diameter.
Do not use rubber hosing.
The connecting pipe must be at least
½
” inside diameter with gas fittings and must not exceed three feet
in length.
You must install the gas regulator supplied.
Some of the above components must be purchased separately.
Please use a professional installer to connect the gas compliant with applicable I.A.W codes
Leak check all connections using the soapy solution test detailed in the manual.
