11
Operating Instructions - mobiMASTER and mobiFITT
GB
9. Operation
The mobile fuel tank was designed and constructed in such a way that it is as robust, safe, and low maintenance
as possible.
All mobiMASTER and mobiFITT tanks are completely checked for proper function and tightness prior to shipment.
After delivery, it should be confirmed that the tank‘s equipment is complete, and that there is no transport
damage. After the pump set (if not already present) has been installed, and after filling with diesel fuel or
heating oil, the tank is ready for operation.
ATTENTION
Damage to the product
■
■
If the tank or a component of its equipment is damaged, the device must be
put out of operation until the fault has been rectified.
■
■
If a leakage of the tank has been detected, the fluid must be pumped into
another container.
■
■
The supplier of the device must be informed.
Because of the type of liquid stored, and the possible environmental damage resulting from it, the
following instructions are to be observed:
■
■
The tank is only allowed to be filled through the filler neck(
a
fig. 8-1; pos. 9). It is forbidden to overfill
the tank!
■
■
To prevent contamination and damage to the pump system, no contaminated fuel may be stored in
the tank!
■
■
The pump‘s operating instructions are to be read before commissioning and use, and they are to be
complied with. (
a
chapter 10; installed components)
■
■
Filling and discharging may take place only under the supervision of an authorised employee.
■
■
No damage to the fuel tank may occur during transport or storage. The tank‘s equipment is to be
maintained in a usable condition at all times.
■
■
The filter on the suction hose (
a
fig. 8-1; pos. 3) should also be cleaned if necessary when the supply
rate is too low.
■
■
The system is to be protected from interference by unauthorised persons.
■
■
Park the vehicle as close as possible to the tank in order to avoid unnecessary stress to the hose.
(
a
fig. 8-1; pos. 6)
■
■
Take the nozzle (
a
fig. 8-1; pos. 11) out of the holder and insert it into the vehicle‘s filler neck. Press
the trigger only when the pump (
a
fig. 8-1; pos. 10) is running.
■
■
Operate the button located on the right side of the diesel pump to switch on the pump‘s power supply.
(
a
fig. 8-1; pos. 10)
■
■
Press the trigger for filling.
■
■
The nozzle automatically stops when the vehicle‘s tank is completely filled.
■
■
Operate the button to switch off the pump‘s power supply.
■
■
Let the nozzle drip off into the vehicle‘s tank before you fix the nozzle in the holder again.
■
■
Never leave the nozzle switched on when it is not used.
■
■
Close the cover (
a
fig. 8-1; pos. 4) of the mobiMASTER or mobiFITT tank, in order to prevent the
penetration of rain water.
■
■
Any modifications of the device‘s design, equipment and intended use is forbidden without prior
consultation with the manufacturer.
