Premium Leisure Sterling Leisure, Owner'S Manual

Page: 55 / 76

Page 55
For HELP, call 727.573.9611
PROBLEM CAUSE SOLUTION
Water will not
heat Thermostat is
set too low Check and reset to desired temperature
Air open Close air control valve
Dirty filter Check and clean filter
Blown fuse Check and replace fuse
Slide valve
closed Check and open all valves
Cover off Put the cover back on
Hot tub in
Economy
mode Press the Standby button and take out of
Economy
Error Codes: Passion, Essence, Desire, Pure, Pristine
MESSAGE MEANING ACTION REQUIRED
(none ) No message on display.
Power has been cut off to
hot tub. The control panel is disabled until
power returns. Hot tub settings are
preserved.
OHH
HH
The hot tub has shut down
from high heat detection.
One of the sensors
detected 118ºF (48ºC) at
the heater. Do not enter the water. Remove the
cover and allow the water to cool.
Once cool, push any button. If the
hot tub does not reset, turn off the
GFCI and call service.
OHS
OH
The hot tub has overheated
and shut down. One of the
sensors detected that the
hot tub water is 110ºF
(43ºC). Do not enter the water. Remove the
cover and allow the water to cool.
At 107ºF (42ºC), the hot tub resets
automatically. If the hot tub does
not reset, turn off the GFCI and call
service.
ICE
IC
Potential freeze condition
detected (Ice) No action required. The pump will
automatically operate regardless of
the hot tub status.
SnA
SA
Sensor A is not working
correctly. Hot tub is shut
down. Check the sensor "A" plug
connection to circuit board. The
problem may appear temporarily in
an overheat situation and disappear
when the heater cools. If the
problem persists, contact service.
SnB
SB
Sensor B is not working
correctly. Hot tub is shut
down. Check the sensor "B" plug
connection to circuit board. The
problem may appear temporarily in
an overheat situation and disappear
when the heater cools. If the
problem persists, contact service.