Premium Leisure Sterling Leisure, Owner'S Manual

Page: 28 / 76

Page 28
For HELP, call 727.573.9611
r patterns. Press the LIGHT button again to turn off the LED
rn on, see
n the panel.
on,
e panel.
11. Press the Blower button again to turn off the blower.
7. Press the LIGHT button to turn on all lights. Verify that the LED light system
is on. Press the LIGHT button multiple times to cycle through the many
available colo
light system.
8. If equipped, press the Jets 2 button. You should hear the pump tu
water circulating, and see the Jets2 light illuminate o
9. Press the Jets 2 button again to turn off the pump.
10. If equipped, press the Blower button. You should hear the blower turn
see water bubbling, and see the blower light illuminate on th
W a t e r B a l a n c i n g
Note:
d
5 minutes between measurements to allow added chemicals to mix
thor
Perform water balancing weekly and whenever you change water
(or when the hot tub is first filled) to ensure proper water condition.
Once your hot tub reaches 95ºF, use our Bromine Test Strips (not included) an
add the necessary chemicals (not included) to stabilize your water chemistry.
Turn Pump 1 on high speed before starting your tests to distribute chemicals
evenly. Wait
oughly.
Important: Test the condition of your water in the following order:
1. Total Alkalinity (80-120 ppm) – Use our Alkalinity Increaser to raise total
alkalinity and Alkalinity Decreaser to lower it. Low total alkalinity has little
buffering capacity making the pH erratic. High total alkalinity has too much
2. pH
buffering capacity making the pH difficult to change.
(7.2-7.8) – Use Spa Up to raise the pH level and Spa Down to lower it.
Caution:
hot
bacteria and
algae causing bather d n ras rritation.
A pH lower than 7.2 can harm the metal surfaces of your hot
tub and irritate your eyes and skin. A pH higher than 7.8 can
create calcium deposits (scaling) on the shell and equipment.
3. Hardness (150-400 ppm) – Add Increase Calcium until the proper level is
achieved. Unfortunately, there is no practical way to lower the native water
hardness other than using a different source of water when filling your
tub. Low hardness causes equipment corrosion and water foaming.
4. Sanitizer (3.0-5.0 ppm) – Use our Deluxe Bromine Kit to add Bromine until
the proper level is achieved. Neglected hot tub water can breed
isc t, ski omfor he r i s, and/o
Test Range
Total Alkalinity 80-120 ppm
pH 7.2-7.8
Calci ess um Hardn 150-400 ppm
Sanitizer 3.0-5.0 ppm