Premium Leisure Sterling Leisure, Owner'S Manual

Page: 54 / 76

Page 54
For HELP, call 727.573.9611
Passion/Essence/Desire/Pure/Pristine Troubleshooting
PROBLEM CAUSE SOLUTION
Breaker trips Wiring error Load Neutral wire not connected to GFCI
(connected to Neutral bus)
Wrong GFCI GFCI breaker is wrong size
Ozonator (or
blower) wet Remove tube from ozonator (or blower) and
allow 2 days to dry out
Foamy water Soaps, skin
oils, or
undissolved
sanitizer
particles Close the air control valves and allow
filtration cycle to run
Add defoamer
Drain and clean your hot tub
Clean or change filters
Rinse all bathing suits before bathing
Leak
Loose
connection Check and hand-tighten unions at heater &
pumps, or clamps on jets
Drain open Close drain valve or replace cap
Light doesn’t LED burnt out Replace bulb
work Loose wire Check wiring harness to LED
Loose plug Reseat J20 plug on hot tub pack
Low/no jet Air lock Bleed air from the system (page 47)
pressure Dirty filter Check and clean or replace filter
Closed jets Open all jets by turning CCW
Closed valves Open all T-handle shutoff valves on heater
and pumps
ACV open Close air control valves
Low water Fill hot tub 1” above all jets
Moved my hot
tub and Wiring error at
GFCI Check Neutral wiring of GFCI (see diagrams
on pages 10-21
now it doesn’t
work No power to
hot tub Reset circuit breakers on GFCI panel and
main circuit breaker panel
Nothing
works Breaker has
tripped Check and reset breaker. If problem
persists, check for loose electrical
connections. Check for Neutral wiring error
at GFCI.
Fuse blown Check for blown Fuse 4 (F4) inside of spa
pack.
Pump not
running No power to
hot tub Reset circuit breakers on GFCI panel and
main circuit breaker panel
Water does Air lock Bleed air from the system (page 47)
not flow Closed jets Open all jets by turning counterclockwise
ACV open Close air control valves
Water too hot High set
temperature Turn down set temperature on topside
control panel
High ambient
temperature Remove the cover