Installation Guide
ECM-D70T / ECM-D70T1.5
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Do not release the flat-panel until the mounting bracket arms are
fully resting on the elliptical mounting bar.
Install the mount according to the instructions provided by Premier
Mounts. Perform all structural reinforcements before attaching the
flat-panel to the ceiling mount.
Raise the
mounting bracket arms and the attached flat-panel over the
elliptical mounting bar
of the
ECM-D70T.
Lower and center the
mounting bracket arms with the attached flat-panel onto
the
elliptical mounting bar
of the ECM-D70T.
Mounting Bracket Arms
Elliptical Mounting Bar
Do not release the flat-panel until the mounting bracket arms are resting
fully on the elliptical mounting bar.
The cable access ports face the rear of the flat-panel. It may be easier
to pre-wire any cables prior to flat-panel installation (see Page 8).
M6 x 25mm
Screw
3
4
5
1) On each mounting bracket arm, insert and tighten the M6 x 25mm screw in
the larger mounting hole.
2) Repeat the Flat-Panel Installation instructions for the other flat-panel.
Do not over tighten these screws.
Flat-Panel Installation
Page 7
