Installation Guide
ECM-D70T / ECM-D70T1.5
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Griplate™ Washer Installation
Nylon Spacer Installation
Page 6
Flat Panel
Griplate™
Washer
Nylon Spacer
Mounting Bracket
Mount Point
Mounting Screw
Premier Mounts’ Griplate™ Washers are designed to accommodate the
various M4, M6, and M8 hole sizes required by flat-panels.
For Griplate™ installation, the dimples must be facing the flat-panel
for the lower mounting points. For the upper mounting points, the
dimples must be facing away from the flat-panel.
Do not place excessive pressure on the back of the flat-panel, as
this may damage your flat-panel.
The Griplate™ Washer must be installed between the head of the
mounting screw and the mounting bracket as shown.
Does your flat-panel have:
●
Recessed mount points?
●
Uneven mount points?
●
A curved back?
●
Any obstruction near the mount point?
If
Yes
, you must install nylon spacers. Remove the mounting brackets,
Griplate™ washers, and mounting screws from the back of the flat-
panel. Proceed to the
“Nylon Spacer Installation”
section.
If
No
, skip to the
“Flat Panel Installation”
section.
Premier Mounts’ nylon spacers allow you to attach the mounting
bracket to flat-panels which have recessed or uneven mount points.
Each nylon spacer will add distance between the mounting bracket and
your flat-panel.
The nylon spacers must only be installed between the mounting
bracket and your flat-panel.
The nylon spacers will fit M4, M6, and M8 screw sizes.
Proceed to the
“Flat Panel Installation”
section.
M8
M6
M4
