CMF
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 7
Attaching the Bolt Spindles to the Flat-Panel (cont’d)
➊
Attach one (1) black vinyl cap to each of the bolt
spindles (Figure 1).
➋
Pull on the crimp at the end of the cables to tighten the
tension on the bolt spindle cabling (Figure 2).
➌
Wrap the excess cabling around the teeth on the
cabling mounting plate, then tuck the crimp inside
(Figure 3).
Continue to the
“Attaching the Flat Panel to the Wall”
section below.
Bolt Spindle
Black Vinyl Cap
Figure 1
Figure 2
Crimp
Figure 3
Wrap excess cabling around
the plastic teeth
Attaching the Flat-Panel to the Wall
➊
Slide the flat-panel and cable mounting plate into the
mount sliding plate on the wall (Figure 1).
At least two qualified persons are needed to perform
this step.
Use the CMF’s MagnaGuide™ feature to easily align
the plates together.
➋
Use the M5 security Allen wrench and pre-installed
M5 x 16mm security screw to secure the cable
mounting plate to the mount sliding plate (Figure 2).
Go to the
“Using the Kickstand”
section on page 8.
Flat-panel not shown.
Figure 1
Figure 2
M5 x 16mm security screw
