B
WEATHER PROTECTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
123
Repair and Service Manual
699273
SPILT WINDSHIELD
Tool List
Qty.
Wrench, 15 mm ........................................................... 1
Socket, 15 mm ............................................................ 1
Torx Plus Bit, 45 IP ...................................................... 1
Ratchet ........................................................................ 1
Pry Bar ........................................................................ 1
Torque Wrench. in. lbs................................................. 1
Use cation not to warp windshield
when raising and lowering the top
section of windshield.
1.
Remove the lock nuts (27) and bolts (24) securing
the lower portion of the windshield (25) to the vehi-
cle.
2.
Fold down the upper portion of the windshield.
3.
Pull the sashes (31) away from the front strut by pull-
ing towards the front of the vehicle starting from the
top and working down. It may be necessary to pry
the sash away using a small pry bar.
4.
Inspect the rubber grommets (26), lower seal (33),
upper windshield latches (28), sashes (31) and wind-
shield bumpers (32) for damage and replace if nec-
essary.
Assemble in the reverse order of removal using new
lock nuts. Tighten all hardware to the torque values
below.
NOTICE: Do not over-tighten or squeeze the rubber
grommets.
Fig. 5 Split Windshield
Item
Torque Specification
27
70 - 97 in. lbs. (8 - 11 Nm)
Front of Vehicle
Front of Vehicle
Strut
Front of
Vehicle
Strut
Windshield
Strut
27
26
24
33
31
31
28
28
29
31
25
24
26
27
32
PRELIMINARY
