FTS Glide Assembly and Maintenance Guide: Assembling the Equipment
9
To assemble the pulleys:
1.
Install a handle on each pulley assembly using one socket head screw. Fully
tighten using the 4mm hex key.
Note:
To adjust the outside pulley location, lift the handle and slide the
pulley assembly to the desired location.
Figure 5: Handle installation
2.
Lift the handles on the pulley assemblies to unlock them from the track and
then slide them to the bases of the main uprights.
Figure 6: Lower the pulley assemblies to base of main uprights
3.
Remove the two bolts, four washers and two locknuts from each main
upright. Ask your assistant to hold each pulley as you remove the
fasteners. Set the pulleys and fasteners aside.
CAUTION: Make sure you have an assistant hold the pulley while you
remove the attached fasteners. The pulley will fall out of the upper
bracket and may cause injury to you or damage to the equipment.
Figure 7: Pulley removal from main uprights
4.
Have your assistant align the pull-up bar with the main uprights and hold it
in place while you reinsert the pulleys and fasteners. Partially tighten the
four locknuts.
Note:
You may need a stepladder to install the pull-up bar.
Important:
Make sure to position this bar correctly to avoid injury during use.
Figure 8: Attaching the pull-up bar
