5.17i Ellipitical Fitness Crosstrainer
Page 52
Procedure 7.8
- Replacing an Input Drive Assembly
Warning:
Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
Procedure
Note:
The input drive assembly consists of the input pulley assembly and eddy current disk
assembly.
1.
Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2.
Remove the front, top, left and right cover sections as described in Procedure 7.1.
3.
Remove the stairarm assemblies as described in Procedure 7.17.
4.
Remove the crankarm assemblies as described in Procedure 7.6.
5.
Remove the eddy current magnet per Procedure 7.13.
6.
Remove tension from the drive belts and remove the pillow block bearings per Procedure
7.7, steps 6 to 8.
7.
Slide the step up and input belts off of the input drive assembly and remove the input drive
assembly from the EFX. (See Diagrams 7.12 and 7.13).
Diagram 7.11 - Eddy Current Disk
Eddy Current
Disk
Pillow Block
Bearing
Crankarm
