PD6700-0L1 Field-Mount Loop-Powered Process Meter
Instruction Manual
19
Operation
Front Panel Buttons Operation
Button Symbol
Description
Press to Enter or Exit
Programming Mode
Used to Reset Maximum and
Minimum Values
Press to Cycle Displaying
Maximum Value, Minimum
Value, and Input Current in mA
Press to Resume Run Mode in
Lower Display
Press to Acknowledge Alarm (if
Enabled)
Display Maximum, Minimum,
and Input Current
The maximum and minimum values and the
measured input loop current may be displayed
temporarily on the lower display. To display these
values, press the
DISPLAY
button. The meter will
display the word
MAXIMUM
on the lower display and
the maximum value reached (since the last maximum
reset) on the top display. Press the
DISPLAY
button
again and the meter will display the word
MINIMUM
on
the lower display and the minimum value reached on
the top display. Pressing the
RESET
button while
either of these values is displayed will reset that value
to the current display value.
Press the
DISPLAY
button a third time and the meter
will display
LOOP MA
on the lower display and the
measured input current in milliamps (mA) on the top
display. The current display will remain for 10
seconds and then the lower display will return to
normal run mode as programmed in
Configuring the
Display
(
DISPLAY
) on page
13
. Press the
DISPLAY
button a fourth time to return to the normal operation.
The meter will display
RESUME
followed by the run
mode lower display.
Reset Meter to Factory Defaults
When the parameters have been changed in a way
that is difficult to determine what’s happening, it might
be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
Enter the
Advanced
Features Menu
.
Press and hold
Reset
button when
INFO
is shown.
For information on navigating to the
Information
menu, refer to
Advanced Features Menu
(
ADVANCE
) on page
15
.
Press
Enter
when
RESET
DFALTS?
prompt is shown.
Note: If
Enter
is not pressed within three seconds, the
prompt will stop flashing return to showing
INFO
.
MENU
RESET
DISPLAY
ENTER
