Large Display Temperature Meters
Instruction Manual
35
Setup for Latching or Non-Latching Relays (
SetuP
)
Each alarm set point can be set up for latching or non-latching relay
operation independently. This means that a combination of latching and
non-latching relays could be used in this meter. Factory default is non-
latching operation for all relays.
Note
To simplify programming, write down the desired programming
values prior to attempting to program the meter. The
Programmed
Parameter Settings
form, located on page 69, provides a
convenient method to record the user settings; it also provides the
factory setting for most of the programmable parameters.
Press
ENTER
to begin scrolling through the
functions.
72f
When setup (
SEtuP
) appears, press
ENTER
.
setup
The display scrolls through
set 1
,
Set 2
,
set
3
, and
set 4
for set point 1 through set point 4
setup. Press
ENTER
to select latching or non-
latching relay operation for desired set point. If
ENTER
is pressed while scrolling set points,
LatCH
is displayed for 3 seconds.
set 1
then
set 2
then
set 3
then
set 4
Press
ENTER
to program set point for latching or
non-latching relay operation when
LatCH
is
displayed.
LAtCH
Y or n
flashes alternately. Press
ENTER
when
appropriate letter is flashing to make selection.
After selection is made, display shows next set
point or next menu function.
Y or n
then
SEtPts
Press
ACK
button to exit menu scroll and return to reading
mode or wait until meter scrolls through the entire menu.
The display will return to indicate the temperature.
72F
